NS0-163 Online Practice Questions and Answers

Data ONTAP uses inodes in an active file system to reference.

A. disk blocks

B. file segments

C. qtrees

D. snapshots

When using MetroCluster, identify two methods for restricting access to the disaster site node. (Choose 2)

A. Cluster remote

B. Use manual fencing

C. Turn off power to the disaster site node.

D. Use thecf forcetakeover-d command.

E. Use thecfgiveback-f command.

Which ONTAP feature discards identical blocks and replaces them with references to a single shared block?

A. Compaction

B. Compression

C. Deduplication

D. Thin provisioning

Which NetApp solution enables block-level backup and restore from ONTAP to StorageGRID?

A. FabricPool

B. Cloud Backup

C. LockVault

D. SnapRestore

Which resource identifies the number of onboard ports available on an AFF/FAS controller?

A. Interoperability Matrix

B. Hardware Universe

C. BlueXP

D. ActiveIQ Config Advisor

An aggregate is composed of twelve 36-Gigabyte disks. A drive fails and only 72-Gigabyte spare disks are available Data ONTAP will then perform what action?

A. chooses a 72-Gigabyte disk anduse it as is

B. chooses a 72-Gigabyte disk and right-size it

C. halts after 24 hours of running in degraded mode

D. alerts you that there are no 36-Gigabyte disks and wait for one to be inserted

The required hardware to add SyncMirror to an existing Clustered Failover system consists of:

A. Disk shelves and cluster interconnect

B. Disk shelves, adapters and cabling

C. Disk shelves and cabling

D. Disk shelves and termination switches

One method of configuring an interface for takeover is to enter ifconfig interface partner address at the command line. To make tins configuration persistent across reboots, you must enter tins information in the_____file for each appliance.

A. /etc/hosts

B. /etc/rc

C. /voL'volO/home

D. /vol/volO/mount

If an error message indicates that the cluster interconnect adapter itself is faulty, what is your corrective action?

A. Check the cabling of the Channel A disk shelf loop and reseat and tighten any loose cables.

B. Check the cabling of the Channel B disk shelf loop and reseat and tighten any loose cables.

C. Re-cable the cluster interconnect adapter or replace the adapter if needed.

D. Check for network activity.

Which tool is available on a non-NetApp primary system to assist in starting or stopping Snap Vault, modifying NDMP settings, enabling debugging, and capturing trace files?

A. Data Fabric Manaaer

B. Svconfigurator GUI

C. svdebua.exe

D. None of the above