HPE6-A48 Online Practice Questions and Answers

Refer to the exhibits.

Exhibit 1

Exhibit 2 A network administrator adds a new Mobility Controller (MC) to the production Mobility Master (MM) and deploys APs that start broadcasting the employees SSID in the West wing of the building. Suddenly, the employed report client disconnects. When accessing the MM the network administrator notices that the MC is unreachable, then proceeds to access the MC's console and obtains the outputs shown in the exhibits.

What should the network administrator do next to solve the current problem?

A. Decommission the MC from the MM, and add it again.

B. Open a TAC case, and send the output of tar crash.

C. Verify the license pools in the MM.

D. Kill two zombie processes, then reboot the MC.

Refer to the exhibit.

A 7008 Branch Office Controller (BOC) is deployed in a remote office behind a core router. This core router does not support 802.1q encapsulation. The Mobility Controller (MC) is the gateway for two tunneling mode SSIDs, as shown in the exhibit.

Which two different configuration options ensure that wireless users are able to reach the branch network through the router? (Select two.)

A. Configure all ports of the BOC as access ports on the controller VLAN, and change the gateway of clients to the core router IP.

B. Configure the uplink of the BOC as an access port on the controller VLAN, and enable NAT for the SSID VLANs.

C. Configure the uplink of the BOC as a trunk port, tagging the controller and the SSID VLANs, and enable NAT for the SSID VLANs.

D. Configure the uplink of the BOC as an access port on the controller VLAN, and add static router in the router for the SSID VLAN subnets.

E. Configure the uplink of the BOC as a trunk port that permits the controller and the SSID VLANs. The controller VLAN must be native.

Refer to the exhibit.

A network administrator deploys a new Mobility Master (MM)-Mobility Controller (MC) network. To test the solution, the network administrator accessess some of the AP consoles and statistically provisions them. However, these APs do not propagate the configured SSIDs. The network administrator looks at the logs and sees the output shown in the exhibit.

Which actions must the network administrator take to solve the problem?

A. Reprovision one of the APs with a different name, and add new entries with the proper group in the whitelist.

B. Reprovision the AP with a different group, and modify the name of one AP in the whitelist.

C. Create another AP group in the MC's configuration and reprovision one AP with a different group.

D. Reprovision one of the APs with a different name, and modify the name of one AP in the whitelist.

A company has headquarters based in the US and rents internation office space in Mexico City so that 10 employees can work remotely. The company must implement a remote access technology so branch office employees can access all servers at the headquareters.

The office has both wired and wireless internet connectivity, with no restrictions on what device connects to the network. However, ports UDP 4500, 5060, and 5061 are blocked by the primeter firewall.

Which remote access technology is required to allow employees to access the servers at the headquarters?

A. BOC with CAPs

B. IAP VPN

C. RAP

D. VIA

An organization wants to deploy a WLAN infrastructure that provides connectivity to these client categories:

Employees Contractors Guest users Corporate IoT legacy devices that support no authentication or encryption

Employees and contractors must authenticate with company credentials and get network access based on AD group membership. Guest users are required to authenticate with captive portal using predefined credentials. Only employees will run L2 encryption.

Which implementation plan fulfills the requirements while maximizing the channel usage?

A. Create VAP1 to run WPA2-AES and 802.1x authentication, VAP2 to run opensystem encryption with MAC authentication, and VAP3 to run opensystem with captive portal.

B. Create VAP1 to run WPA2-AES and 802.1x authentication, VAP2 to run opensystem encryption with MAC authentication, and VAP3 to run opensystem with captive portal and L2 fail through.

C. Create a single VAP to run WPA2-AES and 802.1x authentication, MAC authentication L2 fail through, captive portal, and VIA support.

D. Create VAP1 to run WPA2-AES and 802.1x authentication, and VAP2 to run opensystem encryption with MAC authentication and captive portal.

Refer to the exhibit.

A network administrator deploys a multizone AP in the campus network in order to provide service for 11 SSIDs. After a few hours, the network administrator realizes that the AP is only broadcasting 5 out of the 11 SSIDs. The missing SSIDs belong to MC1 at IP address 10.254.10.114, and MC4 with IP address

10.2.100.25.

Based on the exhibit, what should the network administrator do next to fix this problem?

A. Confirm that AP12 is certified by the whitelist on MC1 and MC4, and confirm MC1 and MC4 are reachable by AP12.

B. Increase the number of nodes in zones 1 and 4, and confirm MC1 and MC4 are reachable by AP12.

C. Confirm that AP12 is certified by the whitelist on MC1 and MC4, and increase the number of nodes in zones 1 and 4.

D. Reduce the number of nodes in zones 0 and 4, and disband the cluster in zone 0.

Refer to the exhibit.

A network administrator wants to configure an 802.1x supplicamt for a wireless network that includes the following: AES encryption EAP-MSCHAP v2-based user and machine authentication Validation of server certificate in Microsoft Windows 10

The network administrator creates a WLAN profile and selects the change connection settings option. Then the network administrator changes the security type to Microsoft: Protected EAP (PEAP), and enables user and machine authentication under Additonal Settings.

What must the network administrator do next to accomplish the task?

A. Enable user authentication under Settings.

B. Change the security type to Microsoft. Smart Card or other certificate.

C. Enable server certificate validation under Settings.

D. Enable computer autentication under Settings.

A network administrator wants to receive a major alarm every time a controller or an Aruba switch goes down for either a local or an upstream device failure. Which alarm definition must the network administrator create to accomplish this?

A. Option A

B. Option B

C. Option C

Refer to the exhibit.

A network engineer configures some VAPs in customer groups and creates a pool of licenses with enough units for seven APs. The network engineer deploys the first two APs, looks at the ap database, and notices the APs are inactive and experience licensing-related issues.

Based on the show command outputs shown in the exhibit, what must the engineer do to solve the problem?

A. Allocate two more MM-VA licenses to the pool.

B. Allocate two more MC-VA-US licenses to the pool.

C. Allocate seven more MM-VA licenses to the pool.

D. Allocate seven more MC-VA-US licenses to the pool.

Refer to the exhibit.

A network administrator evaluates a deployment to validate that users are assigned to the proper roles. Based on the output shown in the exhibit, what can the network administrator conclude?

A. The MC assigned the machine authentication default user role.

B. The MC assigned the role based on user-derivation rules.

C. The MC assigned the role based on server-derivation rules.

D. The MC assigned the default role of the authentication method.