HPE0-S50 Online Practice Questions and Answers

HOTSPOT

A Synergy integrator has installed a new frame into a rack with two existing frames in the customer's environment. Click where the integrator should verify that the cabling for the management ring was completed correctly.

Hot Area:

DRAG DROP

A customer needs a Synergy solution configuration with 40Gb uplinks that will connect to network equipment in a different rack.

Click and drag the cable type on the left to the corresponding distance between the frame and the network equipment on the right to meet the customer's needs.

Select and Place:

A customer has a multi-frame Synergy solution. The customer's Support team recently missed some important alerts in its Composer interface because each pair of Composers resides on a separate management network. What should the customer do to minimize the risk of this reoccurring?

A. Configure HPE Intelligent Management Center.

B. Implement HPE Synergy Global Dashboard.

C. Configure Remote Support.

D. Implement HPE Systems Insight Manager.

Using composable features, what should a Synergy integrator do to resolve high memory utilization on an HPE Synergy compute module?

A. Use the API to optimize the memory allocation from the HPE Synergy fluid resource pool.

B. Increase the allocated physical memory from the HPE Synergy fluid resource pool, and then reboot the compute module.

C. Take a small outage and reassign the HPE OneView server profile to a higher capacity compute module.

D. Increase the reversed physical memory in the Server Profile (SP), and then reapply.

Refer to the exhibit.

Based on the Synergy configuration shown, what will be the outcome in the event of an end-of-row (EoR) switch failure?

A. Smartlink will be triggered

B. There will be no NIC failover.

C. Uplink bandwidth will decrease.

D. Server and downlinks will fail.

Where can a Synergy integrator find consolidated information describing environmental requirements, configuration scenarios, and installation preparation needs for the HPE Synergy solution?

A. HPE QuickSpecs

B. HPE Synergy Site Planning Guide

C. HPE SalesBuilder for Windows

D. HPE Synergy Planning Tool

A Synergy integrator is modifying the network uplink configuration of a Synergy environment that uses HPE Synergy 40Gb F8 Switch Modules for connectivity.

What must the Synergy integrator do to make the necessary modifications?

A. Connect to the switch module CLI and run the necessary configuration commands.

B. Connect to the end-of-row (EoR) switches and push the configuration to the switch modules.

C. Connect to HPE OneView running on the Composer module to modify the Logical Interconnect Group (LIG) configuration.

D. Connect keyboard, monitor, and mouse to the Frame Link module, and run the network configuration wizard.

A customer has moved a USB bootable drive to another compute module but the compute module fails to boot from the USB device.

What should the Synergy integrator do to resolve this issue?

A. In the server Profile, make sure OS Deployment is set to Deployment Plan.

B. Use UEFI System Utilities to disable the B140i RAID controller.

C. Verify that the USB drive key is enabled in UEFI System Utilities.

D. Make sure PXE boot is disabled.

Which element of the HPE Synergy 12000 Frame protects against loops on the MGMT ports that are connected to the external management network?

A. Image Streamer

B. Frame Link Modules

C. Interconnect Modules

D. Composer

Which component of the HPE Synergy solution enables fast OS deployments to compute modules?

A. HPE Synergy Frame Link

B. HPE Synergy Image Streamer

C. HPE Synergy Composer

D. HPE Synergy Compute