Extreme Networks switches build their forwarding database from the incoming packet field information containing the:
A. Source MAC address.
B. Destination MAC address.
C. Source IP address.
D. Destination IP address.
In order to set the OSPF router ID to 192.168.0.1 in area 7.7.7.7 which of the following CLI commands should be used?
A. config routerid ospf 192.168.0.1 area 7.7.7.7
B. config ospf routerid 192.168.0.1
C. config ospf 192.168.0.1 routerid area 7.7.7.7
D. config 192.168.0.1 ospf routerid
In a Summit 5i switch, a MAC address must be configured for each physical port before routing can be configured.
A. TRUE
B. FALSE
There can be only one frame transmitted at a time on a traditional CSMA-CD Ethernet network. What is the result when more frames are sent at the same time?
A. Runts
B. Jabbers
C. Collisions
D. Jumbo frames
What information is described by the IEEE 802.2 standard?
A. Token-ring
B. ATM
C. FDDI
D. Logical Link Control
The following console speeds are supported when a switch runs in bootROM mode. (Choose the two that apply)
A. 2400 bps
B. 9600 bps
C. 38400 bps
D. 115200 bps
In addition to maintaining an internal log, the switch supports remote logging by way of the UNIX syslog host facility. What would you do to enable remote logging on an Extreme switch?
A. Configure the syslog host to accept and log messages
B. Enable remote logging on the switch using the CLI command: enable syslog
C. Configure remote logging using the CLI command: config syslog add
D. All of these
When changing the password for John Doe management account, using the CLI command: config account johndoe password
A. TRUE
B. FALSE
The Rip hold timer to remain a route in the routing table without receiving updates is?
A. 60 seconds, 2 times the update timer
B. 120 seconds, 4 times the update timer
C. 180 seconds, 6 times the update timer
D. 240 seconds, 8 times the update timer
BGP, OSPF and RIP are interior gateway protocols supported by ExtremeWare.
A. TRUE
B. FALSE