Up to this number of VLANs can be tagged on a single link between Extreme Networks switches.
What is the default value for the RIP garbagetime setting?
A. 30 seconds
B. 60 seconds
C. 120 seconds
D. 180 seconds
Exhibit:
Given this display, how would you find information similar to the SHOW SWITCH command?
A. Click on STATISTICS, then SHOW, then SWITCH.
B. Click on STATISTICS, then SWITCH, then SHOW.
C. Click on STATISTICS, then SHOW.
D. Click on STATISTICS, then SWITCH.
In RIP, poison reverse means that:
A. A route is not advertised to the interface from which it was learned.
B. A route is advertised as unreachable to the interface from which it was learned.
C. Traffic whose source interface does not match the routing table is blackholed.
D. None of these.
Which command would you use to configure the switch to disregard STP for selected VLANs?
A. enable ignore-stp vlan
B. enable ignore-bpdu vlan
C. enable ignore-bpdu stpd
D. enable ignore-stp vlan
You have been assigned the task of configuring an 8-port load share group between two switches that uses the round robin-based algorithm. Which of the following commands will provide you with the desired result?
A. Summit #1: config sharing 1 grouping 1-8 algorithm round-robin, Summit #2: configsharing 1 grouping 1-8 algorithm round-robin
B. Summit #1: enable sharing 1 grouping 1-8 algorithm round-robin, Summit #2: enablesharing 8 grouping 1-8 algorithm round-robin
C. Summit #1: config sharing 1 grouping 1-8 algorithm round-robin, Summit #2: configsharing 8 grouping 1-8 algorithm round-robin
D. Summit #1: enable sharing 1 grouping 1-8 algorithm round-robin, Summit #2: enablesharing 1 grouping 1-8 algorithm round-robin
Which of these are valid load sharing algorithms?
A. Port-based
B. MAC-based
C. Ratio-based
D. All of these.
What steps would you take to configure an SNMP read-write community string called "EU.NT.B9" on your switch?
A. config snmp community read-write eu.nt.b9
B. config snmp add community read-write eu.nt.b9
C. create snmp read-write community eu.nt.b9
D. create snmp add read-write community eu.nt.b9
ESRP-enabled switches can utilize either an IP address or an IPX net ID for their protected VLANs.
A. True
B. False