E20-616 Online Practice Questions and Answers

Which component types are installed in a VMAX 10K Storage Bay?

A. DAE, PDP, PDU, LCC

B. DAE, PDP, PDU, SPS

C. LCC, SPS, PDP, PDU

D. DAE, FAN, PDU, SPS

In a VMAX 20K extended drive loop configuration also known as capacity configurations, what is the maximum number of engines you can install?

A. 4

B. 2

C. 6

D. 8

In a Symmetrix VMAX 40K, which engine is connected to the upper half of Direct Connect Storage bay 1D?

A. 8

B. 7

C. 1

D. 2

What is the maximum amount of cache available in a VMAX 40K Engine using only 32GB DIMM?

A. 256GB

B. 384GB

C. 128GB

D. 96GB

What is the RAID level used in Power Vault devices?

A. No RAID

B. RAID 5

C. RAID 6

D. RAID 1

Which procedure wizard option would you use to validate the configuration before it is loaded into the Symmetrix system?

A. Simulation Utility

B. Procedure Utility

C. Configuration Utility

D. Comparison Utility

A banking customer reported performance a issue in their DB server, which is connected to a dedicated FA on a VMAX array. After initial analysis, a bottleneck was found on the FA level. The customer now plans to add two FAs to share the load. What needs to be considered when performing the upgrade?

A. The new FA's director bit flags should be configured to match the existing one.

B. The new FA bit flags automatically synchronize with other FAs where the host is attached.

C. Disable all FA bit flags on the new FA so the host will continue using the existing FAs bit flags configuration.

D. If you set Director bit flags globally using SymmWin INIT configuration, there is no need to set them on any individual director.

What is a SymmWin Best Practice when configuring disk drives?

A. Smaller drives perform better.

B. Go deep then wide when adding drives.

C. Protection type is irrelevant.

D. Use Raid 5 instead of Raid 6 when data availability is secondary.

On a VMAX 10K, what is a Power Vault requirement?

A. 20 vault devices per engine

B. 32 vault devices per engine

C. Vault devices are configured on the first five drives of all DAEs.

D. Five vault drives per DA slice

Refer to the Exhibit.

While configuring a Multi-Engine VMAX 20K, the CE is connecting Engine numbers 4 and 5 with cables. What is the type and sequence of connections required to connect the Lowest Engine number?

A. Purple Cable; connects F to G and H to 3

B. Green Cable; connects F to G and H to 3

C. Purple Cable; connects F to G and E to 3

D. Green Cable; connects F to G and E to 3