E20-594 Online Practice Questions and Answers

What is the default duration of the Backup window in EMC Avamar?

A. 6 hours

B. 8 hours

C. 10 hours

D. 12 hours

You have completed a file transfer of the EMC Avamar software tar file to the Avamar server.

What would you use to verify that the contents of the EMC Avamar software tar file are not corrupt?

A. md5sum

B. sftp

C. winscp

D. tar

Which application is used to transfer patches to the EMC Avamar switch?

A. sftp

B. ftp

C. scp

D. tftp

Which port on the Avamar server does the client connect to when performing a backup with encryption enabled?

A. 27000

B. 28001

C. 28002

D. 29000

What is used to protect against disk failure In EMC Avamar?

A. RAID

B. RAIN

C. Checkpoints

D. Replication

The mapall command reports an error with node 0.1. Using the probe.xml file shown below, what is the IP

address of this node?

What is the software label for port Gb1 on the back of an EMC Avamar Data Store node?

A. eth3

B. eth1

C. eth2

D. eth0

Which options do the Gen4T M2400 single and multi-node platforms provide?

A. 2.0 TB license capacity, four disks, 2 TB RAID 1, eight Ethernet ports

B. 3.9 TB license capacity, six disks, 2 TB RAID 1, eight Ethernet ports

C. 7.8 TB license capacity, 12 disks, 2 TB + 1 SSD RAID 1, eight Ethernet ports

D. 7.8 TB license capacity, 12 disks, 2 TB RAID 6, eight Ethernet ports

Refer to the exhibit.

You are adding a new Data Domain to a Dell EMC Avamar server. After entering the required information, you go to validate your setting by clicking on "Get Stream Count" and the following message appears.

Based on the exhibit, what is a cause for receiving this error message?

A. Wrong Data Domain hostname

B. Wrong SNMP name

C. Wrong DDboost user password

D. Wrong Version of DDOS

After completing the initial root-to-root system migration, you are ready to switch over to the new target system. You have been performing some critical backups of key systems during this initial replication phase.

Which key step must be done prior to the final switchover to ensure all backups are present on the target?

A. Perform a final catchup replication

B. Perform all required DNS changes

C. Run an MCS flush on the target

D. Run an MCS flush on the source