A sheet of aluminum should be cut with __________.
A. a pair of kitchen scissors
B. a handsaw
C. tin snips
D. a coping saw
To chip or cut wood in close, the best tool is a __________.
A. screwdriver
B. butt chisel
C. framing chisel
D. mortising chisel
In arc welding, TIG stands for __________.
A. Turner Insertion Gas
B. Tungsten Inert Gas
C. Torch Inert Gasification
D. Tin Impressible Galvanisation
When the clutch is engaged on a manual transmission, the clutch pedal will be __________.
A. down
B. up
C. halfway down
D. halfway up
If the engine will not start, the problem could be __________.
A. the clutch slipping
B. a clogged oil filter
C. too much carbon in the drain holes or slots
D. a weak battery
With an automatic transmission, which is the best explanation as to why is there no need for a clutch?
A. There is a torque converter that automatically changes the torque needed.
B. The clutch is responsible for the turning of the wheels but in automatic transmissions, it is replaced by the universal joint.
C. The clutch is already built into the accelerator.
D. The clutch is solely to change gears from 1-5. Automatic cars only use the D or drive gear.
The acoustical chamber that is part of the car exhaust system that lessens engine noise is called __________.
A. a silencer
B. the acoustic pad
C. a muffler
D. the noise-reduction system
The tool that can be used to remove or tighten the spark plugs of an engine is called __________.
A. a hacksaw
B. clamps
C. long nose pliers
D. a spark plug wrench
Which would be the last woodworking plane that you would use to prepare a rough sawn board for finishing?
A. Jointer plane
B. Scrub plane
C. Jack plane
D. Smoothing plane
Which type of saw is designed to make accurate crosscuts at specific angles?
A. Miter saw
B. Swing saw
C. Rip saw
D. Pad saw