An administrator has configured an alarm to be notified when a virtual machine meets either of these
conditions:
High virtual CPU
High active memory consumption.
The alarm is only triggering when both of the conditions are met.
What can be done to correct the alarm behavior?
A. Edit the alarm and select Trigger if ANY of the following conditions are satisfied.
B. Edit the alarm and select Trigger if ALL of the following conditions are satisfied.
C. Create two separate alarms, one for CPU and one for memory and link them together with ESXCLI.
D. Delete the existing alarm and create a new event based alarm.
A VMware vSphere Administrator is tasked with enabling Fault Tolerance (FT) on a VM but is unable to. What is the reason that FT cannot be enabled?
A. The VM has a VMDK that is greater than 2TB.
B. The VM is configured to use Jumbo Frames.
C. The VM has 4 vCPU.
D. The VM is running an operating system that is more than 4 years old.
During the installation of ESXi 6.0, the following error message is reported: Hardware Virtualization is not a feature of the CPU, or is not enabled in the BIOS. Which condition would generate this message?
A. LAHF/SAHF is not enabled in the BIOS.
B. NX/XD is not enabled in the BIOS.
C. SSE3 is not enabled in the BIOS.
D. Hyperthreading is not enabled in the BIOS.
An administrator attempts to install vCenter Single Sign-On Server. The installer returns an error message indicating that the installation failed. Prior to the installation, all setup prerequisites were met. The administrator has generated a vCenter Server Single Sign-On support bundle. Which two files should the administrator analyze to determine the cause of the failure? (Choose two.)
A. Server\utils\logs\imsTrace.log
B. Server\utils\logs\install.txt
C. %TEMP%\utils\logs\vminst.log
D. %TEMP%\vminst.log
What are two benefits of using NFS 4.1 with vSphere 6.x as compared to NFS 3? (Choose two.)
A. NFS 4.1 supports Kerberos Authentication
B. NFS 4.1 supports multipathing
C. NFS 4.1 supports IPv6
D. NFS 4.1 supports hardware acceleration
Which two options does VM Monitoring use to determine if a virtual machine should be reset? (Choose two.)
A. Network activity from the virtual machine
B. I/O activity from the virtual machine
C. CPU activity from the virtual machine
D. Heartbeats from VMware Tools
When a vSphere Administrator powers on a VM with the following configuration, what will be the resulting swap file size?
A. 4 GB
B. 2 GB
C. 3 GB
D. 1 GB
Which three options are available for remediation with Proactive HA? (Choose three.)
A. Quarantine mode for moderate and Power off for severe failure.
B. Quarantine mode for all failures.
C. Power off for all failures.
D. Quarantine mode for moderate and Maintenance mode for severe failure.
E. Maintenance mode for all failures.
Which key combination will let a vSphere Administrator revert to the previous version or build of ESXi?
A. Shift+R
B. Ctrl+R
C. Shift+V
D. Ctrl+Z
When adding a new VLAN to an existing virtual distributed switch, which three steps are necessary? (Choose three.)
A. Right click the vDS and select Distributed Port Group, then select New Distributed Port Group.
B. Right click on the data center, select Distributed Switch, select New Distributed Switch.
C. Specify the VLAN ID and VLAN type.
D. Provide a name for the Distributed Port Group.
E. Specify the number of physical uplinks form the vDS to the VLAN.